8' x 6' Bed Installation Instructions
A - Pan Bracket
B - Right Side Impact Tray Bracket
C - Left Side Impact Tray Bracket
D - Shelf Clip
E - T-Bolt and Nut
F - Unarco T-Bolt Crossbeam
G - Left Side Shelf Beam
H - Right Side Shelf Beam
I - Front and Rear Roller Support Beam
J - Shelf Support Beam
K - Front Shelf Beam
L - Pan Front Sheet
M - Impact Rear Sheet
1 - Start by standing uprights and attaching the T-Bolt Support beams (F). Attach using T-Bolts/Nuts (E). Install 1 across the top front, 1 - bottom front, 1 rear top, and 1 rear bottom.
2 - Next attach the right and left shelf beams (G) & (H) to the
uprights using the shelf clips (D). Position
them so that the multiple "box" shaped cutouts
are pointed towards the front of the shelf. If
you look at the photo that shows (G) and (H)
they are actually pointed in the direction that
they should be installed. The rear of the
shelf should be even with the edge of the
upright. (see photo below). The photo also
shows that the rear clip should go through the
last "opening" in the right and left shelf shelf
3 - Coming from the rear of the shelf, install rear roller support bar (I) with the "teeth" pointed towards the inside of the shelf. To install, slide end of roller support bar into side shelf beams (G) and (H). See photo below. It shows how far to slide it and the tabs that need to be tapped in to secure them and keep them front further sliding.
4 - Install 2 Shelf Support Beams (J), into tabs in left and right side shelf beams (G) and (H). See photo below.
5 - Coming from the front of the shelf, install front roller support bar (I) with "teeth" pointed inward.
6 - Install roller tracks. This is done by pinching the bottom of the tracks and fitting them down over the teeth in the front and rear roller support bars (I). Once you have done that, it will be clear where the front roller support bar (I) should be positioned along the side shelf beams (G) and (H). **** This will also show which tab will need to be tapped in on the side shelf beams (same as how it was done for the rear roller support beam....step 3)
8 - Attach shelf tray bracket (A) to front shelf beam (K) and front
roller support beam (I). See photo below.
The front is finished....now we need to finish the rear.
9 - Install Right and Left Impact Tray Brackets (B) & (C) in right
and left side shelf beams (G) and (H). This is
done by inserting the tabs on the brackets into
the openings on the side shelf beams and sliding
towards the rear. See photo below.